West Jordan Drywall and Sheetrock Service

Sheetrock hanging and taping going on inside a commercial spaceDo you have one or more rooms that could use new walls or ceilings put in?

Or maybe you have to get a few holes in your wall repaired.

Helping You With Your Renovation Project Here in South Jordan

Specialists in installing and restoring interior walls and ceilings.

They perform lots of restoration and remodeling work, but they can frequently make smaller repair jobs as well.

For a standard maintenance assignment, they will patch and repair areas that can be patched and repaired.

Other parts may have to be cut out and replaced.

They work on projects in houses, commercial properties and multi-unit buildings in Sandy and Riverton.

Want Drywall Delivered to Your Salt Lake Valley Home?

Your sheetrock installation process essentially follows these few steps:

1. Trucking the drywall sheets to the job site.

2. Hanging the sheets on the walls.

3. Tidying up and removing trash and unneeded material.

4. Taping the seams and putting on joint compound.

5. Sanding, finishing and applying texture.

When these activities are completed, your new wall and ceiling areas are ready to paint.

They could complete the entire job, from start to finish, or they will work on just the initial few steps or the last couple of steps.

As an example, if you want them to only deliver it, install it up on your ceiling and walls, and leave the rest of the processes for another time, that’s a project they can do as well.

Or some homeowners can hang sheetrock on the walls, but they don’t have the experience to professionally do the seam taping and texturing and finishing parts of the job, so they have them come over to do that.

Other than typical drywall products, they can also supply and put in specialty boards which are intended for use in high moisture rooms like bathrooms or walls which will eventually need to support ceramic tile.

They’re flexible.

Drywall Repair Service Near West Jordan or Sandy

Accidents can happen.

Holes and dents get accidentally made in ceilings and walls all of the time.

And plumbing problems wreck lots of sheetrock also.

Some property owners will attempt to correct little holes or dents on their own.

Most modest holes or dents will get resolved by using a patch kit, some joint compound and a putty knife.

When a property owner puts on a wall patch, sometimes it ends up looking great, but frequently it doesn’t look perfect.

It’s trickier than it looks. It could take some practice to get it to look acceptable.

Holes or other wear and tear in the main spaces of your home should most likely be worked on by somebody with experience repairing them.

It’s hard to make a big patch look seamless.

The final step of the repair program is to build the finish and texture of the new or repaired material so it matches the previous finishes once it is painted.

Categories of Repairs

A typical maintenance project is frequently one of the following areas:

  • Fixing or patching one or two different holes or dents.
  • Repairing a few bad sheets so some areas or room can be painted.
  • Taking off and replacing sheets of sheetrock damaged by water or something else.
  • Completing the removal and replacement of a big area or room. Sometimes because of a water problem or other event.

They can take care of one or two small problems, they will perform significant renovations, or anything in the middle of the two.

Choose Your Finish

As they are completing your walls, they can leave them with any type of finish you wish.

Listed here are the options:Taping and mudding the joints during the installing

Fully unfinished – merely taped, meant for unfinished work areas or garage areas.

Smooth finish – zero extra texture, all ready for paint or wallpaper.

Simple texture – creates a little bit more dimension.

Greater texture – height and dimension added and more challenging to do.

Texture match – make your replacement materials match up with your original ones.

A Little About What They Do South of Salt Lake City

They are a full-service drywall contractor.

They try to carry out competitively priced work which make the homeowners satisfied.

All the material they use in your project are top quality.

They use the finest tools and equipment to get your job done perfectly.

They all do their best to keep the mess down and guard your home and property from dirt and dust.

They do not leave you a messy clean-up task when they’re all done.

They collect up and cart out all the excess supplies and junk.

They carry out a number of different assignments.

While many of them are within residential properties, a certain percentage consists of business buildings too.

They work with commercial owners, individual owners or contractors, just tell them what you want done.

What is This Going to Cost Me?

Whatever your project is, they will give you a quote.

Your cost depends on the range of jobs you would like them to do for you and how sizeable the project is.

They wish they could drive over to each upcoming job site and deliver an in-person price estimate, but that isn’t typically feasible.

However, if you can find time for a short call, they should be able to give you some info right on the phone call.

Somebody Will have to Paint All This

If you do not have somebody planned for the painting component of the process, they could take on that job and get it done for you as well.

But if you would like to hire someone different to paint it, or you wish to do it yourself, that is alright.

Do They Work In Your Neighborhood?

They do a lot of work in the suburbs south of SLC.

They regularly work in West Jordan, Riverton, Draper, Sandy, South Jordan, Midvale, Cottonwood Heights, White City, Herriman and Bluffdale.

Where are Services Available?

  • West Jordan UT
  • Riverton
  • Draper
  • Sandy UT
  • South Jordan UT
  • Midvale
  • Cottonwood Heights
  • White City
  • Herriman
  • Bluffdale

Touch to Call!